Anyking P7 Pro 15.6" One-Cable Freestanding Screen Extender Review (2026): A Spec-Based Look
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
The Anyking P7 Pro is a freestanding triple-screen extender with two 15.6-inch 1920 x 1080 IPS panels, and its point is the single cable: after you install the included display driver, one full-featured USB-C cable runs both screens, with no dock or second video cable. The open frame stands behind laptops up to 17.3 inches, so its 3.9 lb stays off the laptop lid. Anyking lists 280 nits, 60Hz, extended and mirror modes, an integrated speaker, 0-180 degree side-screen rotation and a 90-degree kickstand, and says it works with Windows and macOS including M1, M2 and M3 Macs. We reviewed it from Anyking's listing and published specs only, not hands-on.
What stands out
- Two 15.6 in 1080p IPS panels, 60Hz, 280 nits
- One USB-C cable for both screens (driver required)
- USB-A computers supported with external power
- Freestanding frame for laptops up to 17.3 in
- 3.9 lb, 0.19 in panels, speaker, carry bag
Who it fits
Good fit for
Laptop owners with only one full-featured USB-C port, including base M1, M2 and M3 MacBooks, who want two extra 15.6-inch screens without a dock.
Who should skip it
People who cannot install drivers (locked work laptops), console players, and anyone wanting a brighter panel than 280 nits.
Verdict: A one-cable route to a triple setup for single-port laptops and base M-series Macs, if you can install its driver.
Anyking P7 Pro specs explained
2 x 15.6 in 1920 x 1080 IPS, 60Hz
Two full-size side screens around the laptop.
280 nits
A little below the common 300 nits; fine indoors.
One USB-C cable plus driver
The driver lets one port run both panels, including on base M1-M3 Macs.
USB-A mode with PD power
Older laptops connect over the USB-A to USB-C cable plus external power.
Freestanding, up to 17.3 in, 3.9 lb
The frame stands behind the laptop; side screens rotate 0-180 degrees.
P7 Pro frame and finish
The P7 Pro uses an open frame that stands behind the laptop rather than clamping on, so the lid carries none of its 3.9 lb. The center frame adjusts for laptops up to 17.3 inches, each side screen rotates from 0 to 180 degrees, and the triangular kickstand opens up to 90 degrees. The CNC-machined aluminum housings have a matte finish, each panel is about 0.19 inches thick, and a carry bag is included.
Setting up the Anyking P7 Pro
Install the display driver from the included USB flash drive first, then connect one USB-C cable to a full-featured USB-C port to run both 15.6-inch screens. A USB-A computer uses the included USB-A to USB-C cable plus external power at the PD port, and Anyking advises the included adapter if the laptop's USB-C port cannot supply enough power. Built-in controls set brightness, contrast and volume, and the integrated speaker covers basic sound.
Anyking P7 Pro or KEFEYA P7
Choose the Anyking P7 Pro if your laptop has a single full-featured USB-C port or is a base M1-M3 MacBook, and installing a driver is fine. Choose the KEFEYA P7 if you want a driver-free setup with USB-C or HDMI per screen and your laptop has two video outputs; base M1-M3 MacBooks then need an H6 hub.
Check before you buy
- You can install the Anyking display driver
- Your laptop has a full-featured USB-C port for the P7 Pro
- Your laptop is no wider than 17.3 inches for the Anyking frame
- 280 nits is enough for your room with the P7 Pro
The product at a glance
Anyking 15.6-Inch Freestanding Screen Extender
Best for: Single-port laptops wanting two extra screens
- Screen Size
- 15.6"
- Resolution
- 1920 × 1080
- Refresh Rate
- 60Hz
- Panel Type
- IPS
- Connectivity
- USB-C, USB-A
- Weight
- 3.9 pounds
View on Amazon: Anyking 15.6-Inch Freestanding Screen Extender Affiliate link
Anyking's P7 Pro is a freestanding triple-screen extender: two 15.6-inch 1080p IPS panels (60Hz, 280 nits) that run from one USB-C cable after installing its driver, including on M1-M3 Macs. It fits laptops up to 17.3 in, weighs 3.9 lb, and has a speaker and carry bag.
Pros
- One cable for two screens
- Works with base M1-M3 Macs
- No weight on the laptop lid
Cons
- Driver required
- No HDMI input listed
- 280 nits
Good fit if
- Your laptop has one USB-C video port
- You use a base M-series MacBook
Skip if
- You cannot install drivers
- You want console input
Verdict: The simplest cabling for a triple on single-port laptops.
Specifications side by side
| Spec | Anyking 15.6-Inch Freestanding Screen Extender |
|---|---|
| Screen Size | 15.6" |
| Resolution | 1920 × 1080 |
| Refresh Rate | 60Hz |
| Panel Type | IPS |
| Connectivity | USB-C, USB-A |
| Weight | 3.9 pounds |
| Features | Foldable |
| Display Support | Triple Monitor |
| Dimensions | 15 × 0.87 × 9.39 inches |
| Size | 15.6" Triple Screen |
| Color | Triple Silver |
| Model | P7 Pro |
Frequently asked questions
Does the Anyking P7 Pro need a driver?
Yes, install the display driver from the included USB flash drive before first use.
Does the Anyking P7 Pro work with an M1 MacBook Air?
Anyking lists Windows and macOS compatibility, including M1, M2 and M3 Macs, over one USB-C cable with its driver.
How many cables does the Anyking P7 Pro need?
One full-featured USB-C cable runs both screens; add the adapter if the laptop port lacks power.
Does the Anyking P7 Pro clamp onto the laptop?
No, its open frame stands behind laptops up to 17.3 inches.
How bright is the Anyking P7 Pro?
280 nits per screen.
